evertz 7881TSM-IP, User Manual

Page: 31 / 64

7881TSM-IP
User Manual
Version 1.0
Page - 21
5.
7881TSM-IP CONFIGURATION ON VISTALINK PRO (TS MONITORING)
In this section, card configurations can be accessed by expanding the hardware tab in the navigation tree. Right-
click the appropriate IP address and select “View Configuration” or by double-clicking. Finally, select the desired
tab from the pop-up window that will appear on the right.
When making any changes to the parameters/settings, the apply key must be pressed for them to take effect.
Also, the refresh key (or auto-refresh) may also need to be pressed to see the changes. If the changes are
still not applied, please look at the parameters/settings again or the unit may need power cycle.
STATUS
The unit can be confirmed here if the correct board has been selected by seeing all the statuses of the card. In
the case of the 7881TSM-IP, only TSMIP will be available.
Figure 5-1: VistaLINK PRO Status Tab
ETHERNET PORTS CONTROL
The configurations for the network parameters can be made here. It is important to note that only Data 1 and
Data 2 ports will be used. This is because all data ports are connected together as one instead of individually.
Data 2 port is the only control port. Figure 5-2 shows where these ports must be configured in VistaLINK.
5.2.1. Port Details
•
Data 1 : Where all data is received from.
• Data 2 : The control port of the unit.
• Data 3 & 4 : Not used.
•
Control 1 & 2 : Not used.