background image

(2) MANUAL OVERRIDE

To keep the light on regardless of the motion, you can
override the Automatic Operation. By turning the wall
switch off and on within 2 seconds, the light will remain
on. Users can also set the motion sensor back to
Automatic Operation by turning off the wall switch for at
least 10 seconds and then turn it back on.

TROUBLE SHOOTING

Light does not turn on:

l

 

Confirm that you have made a correct “wiring
connection”.

l

 

Make sure that the bulb has not burned out.

Light remains on:

l

 

Make sure the wiring connection is correct.

l

 

If you set the motion sensor to Manual Override,
remember that you must turn the wall switch off
for at least 10 seconds before switch the motion
sensor on back to Automatic Operation.

l

 

Check if the TIME setting is correct.

SPECIFICATIONS

Power Requirement

AC 220 ~ 240V / 50Hz

Power Cord Requirement H05RN-F, 3G, 1.0mm²

Lighting Load

Max. 150W x 2 PAR38
Bulb

Detection Angle

Up to 180

°

 at 20

°

C

Detection Distance

Up to 12M at 20

°

C

Swiveling Angle

Lamp Part: Horizontal 170°;
Sensor Part: Horizontal 40

°

,

Vertical 60

°

Mounting Height

Recommended 1.8 ~ 2.5M
(5.9 ~ 8.2 Ft) Wall Mount

Wall Switch Control

On / Off / Manual Override

Sensor Operation

Auto

Time Adjustment

5 ± 3 sec ~ 12 ± 3 min

Lux Adjustment

Approx. 0 ~ 1,000 Lux.

Operating Temperature

-20

°

C ~ +40

°

C

Warm Up Time

About 1 min

Protection Class

Class II

Protection Degree

IP44

Safety

CE, GS

INES62EVSPEF

6

Summary of Contents for ES62

Page 1: ... avoid any rotation l The unit can be installed only horizontally FIGURE 1a not vertically FIGURE 1b HORIZONTAL VERTICAL FIGURE 1a 1b IMPORTANT Some local building codes may require installation of this product by a qualified electrician Check your local codes as they apply to your situation If the house wiring is of aluminum consult with an electrician about proper wiring methods Maintenance or r...

Page 2: ...er source FIGURE 4 This will help you operate this motion sensor floodlight with ease See OPERATION for further information Note Keep the bulb away from the wall at least 50mm FIGURE 5 2 FIGURE 5 WIRING INSTRUCTION 1 Switch off the power source or wall switch 2 Remove the wall box s back plate then unscrew two screws on the pressure block FIGURE 6 FIGURE 6 Note There is a UP mark shown on the inte...

Page 3: ...2 TIME ADJUSTMENT The TIME adjustment controls how long the floodlight will stay on after the motion has been detected Turn the TIME control knob clockwise to increase up to about 12 minutes how long the floodlight stays on or anti clockwise to decrease down to about 5 seconds the time delay FIGURE 11 FIGURE 11 3 LITE ADJUSTMENT The LITE adjustment determines at what light level the lighting syste...

Page 4: ...ride remember that you must turn the wall switch off for at least 10 seconds before switch the motion sensor on back to Automatic Operation l Check if the TIME setting is correct SPECIFICATIONS Power Requirement AC 220 240V 50Hz Power Cord Requirement H05RN F 3G 1 0mm Lighting Load Max 150W x 2 PAR38 Bulb Detection Angle Up to 180 at 20 C Detection Distance Up to 12M at 20 C Swiveling Angle Lamp P...

Reviews: