Installation Instructions
LOUVERS
LED
DIVISION OF LOUVERS INTERNATIONAL
ADVANTAGE LED
PLEASE READ ALL INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION. REPLACE ANY CRACKED OR DAMAGED
PROTECTIVE SHIELDS AND ITEMS. THIS FIXTURE MUST BE ASSEMBLED AND INSTALLED BY A QUALIFIED ELECTRICIAN.
MODEL
RATED VOLTAGE
RATED WATTAGE
DRIVER TYPE
PROTECTION
ADV-4-2-LED-48W
AC 120-277V, 50-60 Hz
Max. 48W
Class 2
IP65
ADV-8-2-LED-96W
AC 120-277V, 50-60 Hz
Max. 96W
Class 2
IP65
Technical Data:
Safety Instructions:
1. REMEMBER: This fixture MUST be installed by a qualified electrician.
2. Disconnect the existing lamp from the power supply prior to installation. Let the lamp cool down before replacing the luminaire.
3. DO NOT TOUCH the LED lamp with your bare hands prior to or during installation.
4. Replace the lamp cover if it is broken, cracked or damaged in any way. Never use the fixture without the lamp cover in place.
5. In case of damage, disconnect the lamp from the power supply. DO NOT try to repair the lamp on your own. Repairs must be done by a
qualified electrician or factory service.
6. Please refrain from looking directly into the light source.
7. Please connect fixture with Awg 18 type SJ or SJT grounded cord-set rated minimum 60C.
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT.
POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA FENTE LA PLUS LARGE.
8. Please make sure the ground wire has been connected before turning on the switch.
Installation:
1. Position the cable gland into the line hole in the base.
Through Wire Only
ø 0.827 in.
X 2
2. Assemble the clips into the designated position.
“CLICK”
3. Fix the two ends of the cover and base first.
“CLICK”
Louvers International 851 N. Church Court, Elmhurst, Illinois 60126 │ P: 800.543.3765 │ F: 800.568.8377 www.louversintl.com
8/28/15
Page 1 of 3
