FIGURE 8
(6) Strip approximately 6-8mm insulating part of the
wires from the power cord. Before connection,
ensure that the wall box gasket is firmly seated in
its original place.
(7)
Connect the BROWN wire (Live wire) to the terminal
block “L” mark. Connect the BLUE wire (Neutral wire)
to the terminal block “N” mark (FIGURE 9).
FIGURE 9
(8) Use the pressure block to fix the power cord by
fastening its two screws.
(9) Place the wall plate to the wall box and secure it
with the two screws provided.
SETTING THE LIGHTING SYSTEM
(1)
TEST MODE
l
Turn the Lite control and the Time control anti-
clockwise to the edge – the TEST position (FIGURE
10).
FIGURE 10
l
Turn on the wall switch. The floodlight will turn on for
about 1 minute to warm up. Then it turns off. Walk
through the detection area. The floodlight turns on
when you move and turns off when you stop. Wait
for the floodlight to turn off before moving again to
test the sensor.
4
l
Adjust the motion sensor to cover the desired
detection area. For a smaller coverage area, point
the sensor down; for a larger coverage area, point
the sensor up.
(2) TIME ADJUSTMENT
The TIME adjustment controls how long the floodlight will
stay on after the motion has been detected.
Turn the TIME control knob clockwise to increase (up to
about 12 minutes) how long the floodlight stays on or
anti-clockwise to decrease (down to about 5 seconds)
the time delay (FIGURE 11).
FIGURE 11
(3) LITE ADJUSTMENT
The LITE adjustment determines at what light level the
lighting system will start operating when you set the
sensor to Automatic Operation.
Provisionally turn the LITE control knob to the edge
clockwise at the moon (dusk) position (FIGURE 12). In
this provisional setting mode, the motion sensor’s
remains inactive during daylight. At dusk when you find it
is the LUX level desired for operation, simply set the LITE
control knob to the position that the motion sensor
floodlight will become active as daylight declines.
FIGURE 12
OPERATION
By using the wall switch connected to your motion
sensor floodlight, you can easily select one of two modes
of operation: Automatic Operation and Manual Override.
(1) AUTOMATIC OPERATION
Turn on the wall switch. When the motion sensor detects
motion, the floodlight automatically turns on. The built-in
photocell sensor turns the motion sensor off and on
according to the light level set by the LITE Adjustment.
5
