13
QUICK SETUP AND USE GUIDE
Section 2
GAS
INLET
1~220 VAC
1~220 V
IMPORTANT:
ALWAYS CONSULT A LICENSED ELECTRICIAN AND LOCAL CODES BEFORE
RE-WIRING YOUR WELDER OR ATTEMPTING TO MAKE ANY ELECTRICAL CONNECTION.
NEMA 6-50P
L2,WHITE; HOT (240V 1 PHASE)
L1,BLACK; HOT (240V 1 PHASE)
GREEN GROUND (220/240V 1 PHASE)
QUICK SETUP GUIDE: REAR CONNECTIONS AND WIRING
(US/Canada)
SUPPLIED PLUG IS A
NEMA
6-50P
, THE STANDARD PLUG FOR
MOST 1 PHASE 240 V WELDERS IN THE US AND CANADA.
1
2
3
4
PUSH TO CONNECT TUBING
IMPORTANT: TO PREVENT AIR LEAKS, MAKE SURE TUBING ENDS ARE SQUARELY CUT
AND FULLY INSERTED. TO RELEASE TUBING: PRESS GENTLY ON PLASTIC COLLAR SO
THAT IT COMPRESSES INTO HOUSING AND THEN PULL TUBING OUT.
NOTE:
WHEN ASSEMBLING AIR REGULATOR NOTICE THE MARKING S THAT ARE
STAMPED ON TOP OF THE REGULATOR HOUSING FOR AIR FLOW DIRECTION. AIR FLOW
DIRECTION WILL BE NOTED AS IN/OUT OR BE STAMPED WITH A SMALL ARROW FOR AIR
FLOW DIRECTION. THE QUICK CONNECT 1/4” MALE AUTOMOTIVE COUPLING SHOULD BE
MOUNTED ON THE SIDE OF THE REGULATOR WITH “IN” OR THE ARROW POINTING TO THE
MIDDLE OF THE REGULATOR. ALSO THE BRASS PLUG INCLUDED WITH THE ACCESSORY
PACKAGE SHOULD BE MOUNTED IN THE CENTER HOLE.
Summary of Contents for PowerPlasma 60S
Page 26: ...26...
