20
Setup Guide and Component Identification
Section 2
CONNECTIONS AND POLARITY
DC TIG ONLY! (GTAW
-
DC)
The foot pedal and the torch switch cannot be connected at the same time. The torch switch may remain attached to the
torch, but since they both use the control connection and serve a similar purpose only may be used at a time.
Note:
The
unit is supplied with a water
-
cooled torch and the diagram depicts proper connection for water
-
cooled torches. Do not use
this torch without a water cooler or torch damage will occur. To determine the gas line blow through the lines with com-
pressed air. Improper connection will result in no gas flow or water coming out of the torch head. For an air
-
cooled torch
alternative (all air
-
cooled torches handle 200 amps or less), contact Everlast for a full range of Everlast and NOVA torches.
WORK
+
TORCH
-
PEDAL
TO CONTROL
SWITCH
TO COOLER
GAS
FROM COOLER
Note: Pictured, Water
-
Cooled Setup.
Although fitted with
a water cooler power plug on the rear, the water cooler is
optional and must be purchased separately. The unit comes
with a 26 series air
-
cooled TIG torch to support the 200 amp
capability of the welder. To connect the 26 series, the
DINSE connector return line pictured below as
“
to cooler
”
actually becomes the gas line. If needed, any series and
brand torch, including any water
-
cooled torch may be fitted
to the unit, including water cooled A DINSE 35 connector
will have to be purchased from the torch supplier in addition
to the torch. However, to simplify this process, contact Ever-
last for a NOVA brand torch product that is for a high
-
quality, flexible torch specifically designed to fit your unit.
