EPRO NVR Series
51
Buzzer:
Set up the time for buzzer to sound when an alarm is triggered.
Post Recording:
Select a post recording time when an alarm is triggered.
Alarm Out:
Check the box to enable the alarm output.
Show Message:
Check the box to enable the function. When an alarm is triggered, an alarm
message will be displayed on the live screen.
Send Email:
Check the box to enable the function. When alarm is triggered, the NVR will
send an email alert to the receiver. Note that for this function to work, you have to set up
the Email function in advance (refer to
4.1.1.3.2 Email
).
Full Screen:
Check the box to enable the function. When alarm is triggered, the
corresponding channel with the alarm will be switched to full screen on the live screen.
Record Channel:
Check the box to enable the function. When alarm is triggered, the selected
channel(s) will be recorded.
Copy:
You can apply the same configurations from one channel to the desired channels.
Select a channel from the
Copy
drop-down list first and then select a desired channel (or All)
from the
To
drop-down list, click the
Copy
button, the selected channel(s) will be applied
with the same configurations.
Click
Default
to return to factory default value,
Save
to save the settings, or
Cancel
to cancel
and leave the page.
The alarm types and descriptions are listed as below:
Alarm Type Functions and Descriptions
Video Loss
When NVR fails to receive video signals due to some problems (camera
damage, cable dropout or damage, power failure), the alarm will appear.
Motion
Detection
When IP camera detects moving objects, alarm will be triggered. Sensitivity
is subject to the actual application environment test. Sensitivity is adjusted
according to the sensitivity of moving object detection and parameters are
modified by combining the area setting.
I/O Status
Communicate with alarm device through I/O port. Alarm signals sent by IR
sensor or other devices will be transformed to the system recognized signal
and activate relevant channel to record or control the device output.
HDD Status Alarm will appear when HDD does not work due to damage, power failure,
HDD auto-overwrite off and insufficient space.
