ECOR960 X1
61
Resolution:
Select the most suitable resolution for your needs. Please note that if you select
different modes in the Aspect Ratio drop-down list at the Display Setting page (please refer to
6.8.1 Monitor OSD
), there will be different resolution options in this selection list as follows:
WD1 Mode: 960x480 / 480x240 (NTSC)
960x576 / 480x288 (PAL)
D1 Mode: 720x480 / 720x240 / 352x240 (NTSC)
704x576 / 704x288 / 352x288 (PAL)
Record Quality:
Select a recording quality for the Main Stream and Sub Stream. The options
include Low, Basic, Standard, High and Superior. The higher the quality, the more the HDD
space is used.
Normal Speed:
Select a frame rate per second (FPS) for continuous recording. The speed is
limited by the maximum total recording capacity of the DVR as allocated across all the
installed cameras.
Event Speed:
Select a frame rate per second (FPS) for event recording.
Record Audio:
Check the box to enable audio recording on the DVR. Note that the Audio
function is unavailable for Germany.
PTZ ID:
To allow the DVR to recognize and then control the connected PTZ camera, you have
to set up an ID for the PTZ camera. Select
On
and then enter an
ID
for the camera. This ID
must match the ID address set up on the PTZ camera. For setting up the ID address on the PTZ
camera, please refer to the User’s Manual of your PTZ camera.
PTZ:
Select a PTZ speed. The higher the number is, the faster the speed is.
Apply To:
Click the button to apply the same settings to the desired cameras.
