DESIGNED TO PERFECTION
GENERAL INFORMATION
Before installing and operating the range hood,
carefully read the following important information
regarding installation safety and maintenance. Keep this
information booklet accessible for further consultations.
The appliance has been designed to exhaust cooking
fumes externally. Before installation, please ensure that
the following have been supplied and that the tools
listed below are readily available.
WHAT IS SUPPLIED
Range hood (including one way valve for flue x 1) x 1.
Installation kit x 1 – 8mm bolts x 10, 30mm screws x 2, 40mm screws x 7, plastic plugs x 9.
Mounting brackets x 3.
Exhaust tube x 1.
Instruction booklet x 1.
WHAT MAY BE NEEDED FOR INSTALLATION
Electric Drill
Duct Tape
Screwdrivers
Tape Measure
Jig Saw
Torch (If natural lighting is minimal)
Spirit Level
Ladder
INSTALLATION INSTRUCTIONS
Please ensure that before installing the range hood, all power is switched off.
Installation must be in accordance to the local electrical authority and codes.
This range hood must be earthed at all times for the operators’ safety.
The switched power outlet for the range hood should be positioned to enable the user to turn the power off,
to enable cleaning and any maintenance required.
The switched power outlet should be installed within 600mm from the rear of the unit.
Ensure that when installing the range hood, that it is protected from any possible damage from tools etc.
Ducting for this unit must be installed in accordance to the local authority.
Ensure that the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure that it is structurally sound.
The Everdure RBES67 & RBES97 range hoods are intended to be installed directly onto a wall.
NOTE: Everdure recommends these appliances are installed as ducted appliances. If they are installed as
recycling appliances (venting air back into the room through the ducts in the flue), do not use the exhaust
tube, leave a small gap at the top or behind the flue to allow more airflow & always use the correct charcoal
filters (CF 160), which must be replaced every 4-6 weeks.
4
4
