Assembly
1
2
WARNING:
Ensure drill is not connected to electrical
service
as you begin this process.
Inspect the washer in the inlet hose to make sure it is in
good condition and installed in the hose.
Connect
B
1
2
Preparing to pump motor oil
using adapter and tube.
Preparing to pump clean water using
garden hoses connected to the pump
Attach the garden hose (C) to port (2).
Connect the drill power cord to a 3-wire grounded plug
Remove the dipstick from the engine/motor from which you
Cut at a 60° angle at one end of tube (A).
Place the adapter tube (A) into the inlet port (1) of the pump (B)
as far as it will go.
Insert the end of the tube (A) with the 60° cut into the motor
dipstick hole.
plan to remove motor oil.
Lubricate the pump impeller by placing several drops of
vegetable oil on the impeller at inlet port (1).
Attach the drill pump with tubes and hose to the drill
WARNING:
To minimize the pump rotating on the drill,
firmly grip the drill pump in a gloved hand and hold it as
NOTE
: Motor oil should be removed when it is at room
WARNING:
Ensure motor oil is drawn into the drill pump
within 10 seconds to avoid damaging the pump. If it
does not, check to ensure the tube (A) is firmly inserted in
pump (B), ensure the tube is not crimped, and ensure the
tube is fully inserted in the motor dipstick hole.
temperature.
WARNING:
Ensure drill is not connected to electrical
service
as you begin this process.
Lubricate the pump impeller by placing several drops of
vegetable oil on the impeller at inlet port (1).
port (2) on pump (B).
WARNING:
The combined height of the inlet and
outlet hose should be no higher than 8 ft. above the
water source and/or not more than 25ft. horizontally
CAUTION:
Keep the inlet hose as short as possible.
from the water source.
Connect the drill power cord to a 3-wire grounded plug,
Attach the drill pump with hoses to the drill.
WARNING:
Ensure water is drawn into the drill pump
within 10 seconds to avoid damaging the pump. If it
does not, check to ensure the hose connections are firmly
installed to the pump (B), ensure none of the hoses are
crimped, and ensure the suction hose is fully inserted
into the water source.
Should the water have suspended solids
in it, a strainer should be installed on that part of hose
that is in the water. A piece of door screen wrapped and
held with a wire tie to the end of the hose in the water
source would be an example of a strainer.
CAUTION:
B
A
1
C
OUT
IN
OUT
IN
Garden hose
(sold separately)
use garden hose provided
for discharge only
C
5
HOMEDEPOT.COM
Please contact 1-844-883-1872 for further assistance.
and ensure drill is set to the proper rotational direction.
(If using a corded drill).
you start the drill.
Lower viscosity oil is easier to pump.
a heavy duty, thick-walled garden hose to the inlet
port (1) and hose to outlet
if using a corded drill.
WARNING:
To minimize the pump rotating on the drill,
firmly grip the drill pump in a gloved hand and hold it as
you start the drill.
CAUTION:
Do not pump oil if debris / metal shavings
are present.
NOTE
: Water should be removed when it is at room
temperature.
2
