DIR911 Instant Recall Recorder
©2000 Eventide Inc.
14
BEEP CONFIGURATION Screen
-
Enable/Disable beep, set level of beep tone on
telephone line
This is the beep configuration screen. A 1kHz beep tone can be injected on the phone
line to let the user and others know that they are being recorded. “CHANGE” steps
between enabled and disabled.
When the CONSTANT key is activated, a constant beep tone is added to the telephone
input signal. This allows you to set the volume level of the beep as compared to the
level of the incoming signal. The constant tone is used only for adjusting the beep
signal level. The “Beep Adjust” trim pot on the back panel of the DIR911 allows you to
set the level of the beep tone on the recording. After completing beep level adjustment,
then press “STOP” and set the beep enabled or disabled. Check it by plugging a set of
headphones into the Monitor jack. The default beep setting is DISABLED.
CONFIG 2 Screen
-
Leads to Change/View sampling rate, security configuration, and
message information
Using configuration screen 2, you can configure/change/review the sampling rate,
security configuration including password configuration and security level, and message
information. “MORE” leads to the Config 3 screen.
SAMPLING Screen
-
Changing the sampling/transcoding rate
As of current version, there is only one transcoding rate available, 32kbps. Eventide
plans to add 64kbps at a later date. With the standard 16MB of DRAM, 64 minutes is
available for recording at 32kbps, and 32 minutes is available at 64kbps. With an
additional 16MB (total of 32) of DRAM
128 minutes is available for recording at 32kbps,
and 64 minutes is available at 64kbps.
IMPORTANT NOTE
: If you change the transcoding rate, the unit is effectively “reset”
and all message audio and information is cleared.
The beep is currently: DISABLED
CHANGE CONSTANT DONE
DIR911 System Configuration
SAMPLING SECURITY MSG INFO MORE
Transcoding Rate: 32 kbps
CHANGE DONE
