24
25
PLAC
E
AT
ARMPIT
LEVEL
PUSH
1. Remove Lower
Anchor Connectors
from the forward-
facing belt path.
Reach through the
harness straps and
remove each Lower
Anchor Connector, one
at a time.
PLACE
AT
ARMPIT
LEVEL
PUSH
2. Place each Lower
Anchor Connector
in the rear-facing
belt path.
PLACE
AT
ARMPIT
LEVEL
PUSH
3. Make sure the
crotch buckle
assembly is
positioned in
front of the Lower
Anchor Connector
Assembly, as
shown.
Note:
Do not forget to install the seat pad before
installing the child restraint in your vehicle.
Moving Lower Anchor Connector
Assembly to Rear-facing Belt Path
1. Place the child
restraint in position.
Adjust the child restraint
to the
most
reclined
position (
Recline Position
#1, p. 58
), then place it on
the vehicle seat in the rear-
facing position, as shown.
buc
kle
storage
2. Attach Lower Anchor Connectors.
Push a Lower Anchor Connector onto
each
vehicle
Lower Anchor Bar.
Note:
You may need to
vary the angle
of the Lower
Anchor Connectors, as shown above, to attach to the
Lower Anchor Bars. Also, make sure the Lower Anchor
Connector Assembly is in the rear-facing belt path (p. 23).
Far side
Lower Anchor Bar
Near Side
IMPORTANT:
• If you are using the vehicle seat belt to secure the child
restraint,
DO NOT
use Lower Anchor Connectors.
•
DO NOT
use the Tether Strap when the child restraint is
in the rear-facing position
.
Rear-facing Installation with Lower
Anchor Connectors
IMPORTANT:
Make sure both Quick Connectors or SureLatch
Connectors are facing upward and the straps are not twisted.
Correct
Incorrect
Strap
SureLatch
Quick Connector
Rear-facing
Lower Anchor Bar
IMPORTANT:
Make sure
the Lower Anchor Connector
Assembly does not interfere
with the internal harness
straps.
