36
37
For
ward-facing
PL
ACE
AT
ARMPIT
LEVEL
PUSH
1. Remove Lower
Anchor Connectors
from the rear-facing
belt path.
PLAC
E
AT
ARMPIT
LEVEL
PUSH
2. Place each Lower
Anchor Connector
in the forward-
facing belt path.
Pull the harness strap out
of the way and insert a
Lower Anchor Connector,
behind
the straps, into
the forward-facing belt
path opening, as shown.
Repeat on the other side.
Note:
Do not forget to install the seat pad before
installing the child restraint in your vehicle.
Moving Lower Anchor Connector
Assembly to Forward-facing Belt Path
Forward-facing Installation with
Lower Anchor Connectors
IMPORTANT:
Make sure
the Lower Anchor Connector
Assembly does not interfere
with the internal harness
straps.
LATCH
is a system for attaching the child restraint to your vehicle
seat. It is to be used in place of your vehicle’s seat belts and can
be used in vehicles with LATCH anchors.
Your vehicle owner’s
manual may refer to this system as ISOFIX, Universal Anchorage
System (UAS), or Lower Universal Anchorage System.
•
ONLY
use for securing child restraint to vehicle Lower
Anchor Bars.
•
ALWAYS
read and follow exactly the instructions which
accompany your vehicle and child restraint.
•
NEVER
attach two Lower Anchor Connectors to one vehicle
Lower Anchor Bar.
•
DO NOT
use the vehicle seat belts to install a child restraint
when using the Lower Anchor Connector Assembly.
• This Lower Anchor Connector Assembly is intended to be
used
ONLY
as described in these instructions.
Serious injury or death may result from misuse.
•
ALWAYS
be sure that the Lower Anchor Connectors are
attached to the vehicle Lower Anchor Bars by pulling
hard on the Lower Anchor Connectors. If they are not
attached, the Lower Anchor Connector Assembly will not
secure your child restraint. Serious injury or death may
result.
• To avoid a strangulation hazard, you
MUST
store the
unused Lower Anchor Connector Assembly, with all slack
removed, in storage area on the seat (p. 56). Roll or fold
excess Lower Anchor Connector Strap and secure with a
rubber band to prevent serious injury to vehicle occupants.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of child
restraints and LATCH. If there is a discrepancy, follow your
vehicle owner’s manual.
WARNING
buckle
sto
ra
ge
DO NOT
install by this
method for a child weighing
more than 20.4 kg (45 lbs).
PLACE
AT
ARMPIT
LEVEL
PUSH
