EVCO | 21.10.2020 | AZ
| 8
008_EVLJBOX_Sequencer_Installazione_001_0.1_AZ
008_EVLJBOX_Sequencer_Installazione-02_001_0.1_AZ
008_EVLJBOX_Sequencer_Installazione-02_001_0.1_AZ
c-pro 3 OEM
144EJBSI104
EVLJBOX HP Sequencer -
Application manual
Installation
INSTALLATION PRECAUTIONS
–
Ensure that the working conditions are within the limits stated in the “
Technical specifications
” section.
–
Do not install the device close to heat sources, equipment with a strong magnetic field, in places subject to direct
sunlight, rain, damp, excessive dust, mechanical vibrations or shocks.
–
In compliance with safety regulations, the device must be installed properly to ensure adequate protection from
contact with electrical parts. All protective parts must be fixed in such a way as to need the aid of a tool to remove
them.
–
Users will need a rigid pipe fitting; the maximum diameter of the fixing hole must be 28.5 mm
–
To ensure IP65-rated protection of the whole casing, fix the container using only the holes already made
Wall mounting
1. Secure the back cover |
7
| to the wall using the 4 screws
|
1
|
and the holes already made |
6
|
2. Make sure the seal |
8
| is correctly inserted
3. Place the front cover |
4
| over the back cover
|
7
| and push the 2 assembling tongues |
10
|
down into the holes |
2
| on the right or left
of the front cover |
4
|
4. Fix the user interface |
12
| into place by pressing it
into its housing |
5
| from the front
5. Fix the control module |
14
| to the DIN rail |
16
|;
next secure the DIN rail |
16
| to the back cover
|
7
| in its housing |
17
| with two screws |
15
|
6. If the connection cables are fed in from above,
make a hole whose diameter is suitable for fixing
a rigid pipe fitting |
13
| on the top of the
back cover |
7
|; if the cables are fed in from the
bottom, make the hole on the bottom of the cover
7.
Screw the rigid pipe fitting |
13
| to the back
cover |
7
|
8. Connect the user interface |
12
| as shown in the
section “
Electrical connections
”, feeding the
connection cables through the rigid pipe fitting |
13
|
9. Secure the front cover |
4
| to the back cover |
7
|
using the 4 screws |
9
| and the holes already made |
3
|
10. Fix the covering strips |
11
| over the top and bottom
parts of the front cover |
4
|
7
4
5
1
9
13
15
14
16
17
17
10
11
12
2
6
8
3