Eurotherm 584SV Series, Product Manual

Page: 40 / 255

604;##
,QVWDOOLQJ # WKH # ,QYHUWHU
8;7 69 # 6HULHV # )UHTXHQF\ # ,QYHUWHU
4. Remove the drive-mounted Operator Station’s cable from the RS232 programming port (P3)
on the Control Board PCB. The removed cable and connector are insulated and can be safely
left in-situ. Connect the supplied cable (either end) to the P3 port on the Control Board PCB.
5. Route the cable from the Inverter to the remotely-mounted Operator Station and secure,
ensuring that adequate protection from live parts and abrasion is achieved.
6. Finally, connect the free end to the remotely-mounted Operator Station.
&XWRXW # 'LPHQVLRQV
7;15
Figure 3-23 Mounting Dimensions for the Remote-Mounted Operator Station 5841
7RS # &RYHU
This is fitted to wall-mounted 584SV units to give improved compliance ratings. Refer to
Chapter 11: “Technical Specifications” - Environmental Details.
The top cover fixing screw has
a maximum tightening torque of 1.5Nm (1.2Nm recommended).
*ODQG # %R[
This is also fitted to wall-mounted 584SV units to give improved compliance ratings. Refer to
Chapter 11: “Technical Specifications” - Environmental Details.
6SHHG # )HHGEDFN # 2SWLRQV
There are two speed feedback card options:
0LFURWDFK
An additional card is necessary to implement speed feedback from a Microtach (ENG block 6 of
Product Code). For specification and connection information refer to 5901 Microtach Technical
Manual. The maximum speed that the 584SV will accept from a Microtach depends on its
resolution (number of lines per revolution). The limit, in RPM is:
with an overriding limit of 24000 RPM.
3 x 10
resolution
6