Eurotherm Drives 635, Product Manual, Page: 56 / 79

56
Product-manual Model: 635/DER u. 635/K DER 07-01-05-06-E-V1002.doc
Commissioning
8.2 Commissioning in steps
Step Action Remark
1 Before switching on
Check the wirung, especially:
Filterpolarity, supply
motor wiring, motor polarity
resolver wiring, polarity (or other feedback systems)
2 with critical mechanical parts: remove motor shaft from
application avoid danger
3 Connect PC by RS232 link to the drive service port
COM1 and start EASYRIDER
4 Set up state
NOT ACTIVE (X10.22 against X10.9)
Power ON
7-Segment-display
5
Switch on control voltage Us (DC 24V)
EASYRIDER communicates
(see diagnosis F9)
7-Segment-display
6
Are parameters already evaluated ?
yes: load parameter file
xxx.ASD.
Store parameters in the drive.
If existent: load BIAS-file
xxx.EEUROTHERM and
store it in the drive.
proceed with
10 or 15 (experts)
no: continue with 7
7
Menue Comissioning:
Select the used motor from the EASYRIDER- Library
Adjust max. current to nominal motor current or smaller reduced torque
8 When leaving that menue:
Tuning-parameters for current loop will be calcualated
and offered to the user.
Normally, these values give dynamic servo motion. confirm acceptance of offered
parameters
9
store data power-fail-save in the drive (F7)
10 Menue: Tuning speed loop