Issue 2, Nov-98. Applies to software versions 1.3 & 1.4 -5- HA026270
Automatic Tuning List (See page 10)
Adjustable Range
Default Setting
Customer setting
Automatic Tune Enable
or
!!
"
Automatic Manual reset calculation (when
P+D control)
or
#
#
PID List (See page 10)
Adjustable Range
Default Setting
Customer setting
Proportional Band
to
display units
Integral Time
to
seconds
$
Derivative Time
to
seconds
$
%
Manual Reset Value
(only present if
=
)
to
%
"
Low Cutback
to
display units
"
High Cutback
to
display units
%&
Relative Cool Gain
to
Setpoint List (See “To Use the Timer” on
page 6)
Adjustable Range
Default Setting
Customer setting
Setpoint Low Limit
to
As per order
Setpoint High Limit
to
As per order
%%
Setpoint Rate Limit
to
display units per minute
!!
Timer Operating Mode
to
'
%
Time Remaining
to
minutes
(
Dwell Time
to
minutes
Timer Status
or
Input List (See “User Calibration” on page 9)
Adjustable Range
Default Setting
Customer setting
Input Filter Time Constant
to
seconds
$
&)&
Cold Junction Temperature measured at rear terminals
Read only
Millivolt Input measured at the rear terminals
Read only
Process value Offset
to
display units
&
Calibration Password
to
&
User Calibration Enable
&
Re-instates factory calibration
*%
Re-instates user calibration
&
Low Calibration Point
to
display units
Low Point Calibration Offset
to
display units
High Calibration Point
to
display units
High Point Calibration Offset
to
display units
Output List
Adjustable Range
Default Setting
Customer setting
Low Output Power Limit
to
%
High Output Power Limit
to
%
&&
Heating Output Cycle Time
to
seconds
Lgc
Rly
&&&
Cooling Output Cycle Time
to
seconds
'
Lgc
Rly
Heating Output Minimum On Time
to
seconds (Auto = 50ms)
&
Cooling Output Minimum On Time
to
seconds (Auto = 50ms)
On Off Output List
Adjustable Range
Default Setting
Customer setting
+
Heating Hysteresis
to
display units
+&
Cooling Hysteresis
to
display units
&
Heat/Cool Deadband
to
display units
&&
&&
Access List (See “To Hide, Reveal and
Promote” parameters on page 6)
Adjustable Range
Default Setting
Customer setting
"
Access Pass Number
to
,
Go To Required Access Level
%
&!
Configuration Pass Number
to
