Advanced Configuration
VoIP²ALL 8 - 16 - 24 Channel Gateway User Guide
www.eurotech-communication.com
54
5)
Confirm new password.
6)
Click
Update Password
.
4.8.6.
RESETTING THE GATEWAY
You can reset the Gateway from the management software.
To reset the Gateway:
1)
From the Main Toolbar, click
System
.
2)
In the
Setting
tab, click
Reset System
.
4.9.
CONFIGURING SPECIAL FEATURES
The section describes how to use VoIP²ALL's special features, including:
Network Announcement Message Detection
on page 54
Port Test Calls
on page 55
Source Routing
on page 55
IVR
on page 56
Callback
on page 58
DISA (Direct Inward Access System)
on page 58
BCCH Configuration
on page 59
Sending and Receiving SMS
on page 61
4.9.1.
NETWORK ANNOUNCEMENT MESSAGE DETECTION
This advanced feature is designed to block cellular network messages.
The cellular network answers a call with a message faster than a mobile phone.
When enabled, if the Gateway detects that the call was answered below the
Connection Time
, it
disconnects the call. After a number of consecutive detections, defined in
Number of detection,
it
blocks the SIM. See
Blocking SIMs
on page 42.
Note: This feature works only when the network message comes with
Connect
.
To configure Network Announcement Message Detection:
1)
On the Main Toolbar, click
Ports
.
2)
In the
Network Announcement Message Detection
section, check
Active
.
3)
In
Connection Time(sec)
, enter the maximum time in seconds the
Connect
message takes to
arrive.
Note: Setting the connection time higher than 6 seconds may result in regular calls being
disconnected.
4)
In the
Number of Detections
, enter the number of consecutive network messages detections
before the SIM is blocked.
5)
Press
Save
.
