Eurotech VoIP2 ALL Series, User Manual

Page: 28 / 77

Advanced Configuration
VoIP²ALL 8 - 16 - 24 Channel Gateway User Guide
www.eurotech-communication.com
28

If two or more ports have the same prefix then the Gateway will divide the calls between the
ports.
5)
(Optional) You can modify the dialing number received from the SIP which the Gateway uses to
dial out by using the following parameters:

Remove Prefix - Select how many digits to remove from the beginning of the dialed number.

Add Prefix - Enter the digits to be added at the beginning of the number.
6)
In Prefix Type select one of the following options:

Include - to only call the prefixes that included in the table

Exclude - to only call the prefixes that are excluded from the table
7)
(Optional) In the General section you can configure the following settings:

Active - This enables outgoing calls from the selected port.

Start Delay - This value in seconds is the delay time after registration until the start of calls.

Connect Time - This defines when the voice from the called party is connected. There are
three options:

Very early - (default) From Alerting the called party

Early - From Ringing of the called party

Normal - From Connect of the called party
1)
Press Save.
4.4.2. HANDLING INCOMING CALLS

To handle incoming calls:
1)
From the Main Toolbar, click Ports .
2)
Select a port from the list on the left.
3)
Select the Prefixes tab. A prefix table for the selected port is displayed.
4)
In Incoming Calls Handle select the operation mode for each port:

Dial Tone - All calls that come to this port receive a dial tone when calling any other port.

Blocked - All calls that come to this port are blocked. The caller hears a busy signal.

Destination Number - All calls that come to this port are automatically routed to a number
according to the Incoming Calls Destination mode.

IVR - All calls that come to this port receive the IVR message. For details, see IVR on page 56.
5)
Click Save .
4.4.2.1. AUTOMATIC ROUTING
This section describes how to configure the ports to automatically route incoming calls to predefined
destination numbers.

To route incoming calls to predefined numbers:
1)
From the Main Toolbar, click Ports .
2)
Select a port from the list on the left.
3)
Select the Prefixes tab. A prefix table for the selected port is displayed.
4)
In Incoming Calls Handle , select Destination Num .