EUROSTER 4010TXRX
–
INSTALLATION AND OPERATION MANUAL
5
8.
TEST MODE (tSt)
In the test mode, you may check the main parameters of the thermostat. In order to enter the
test mode press and hold the
central and left “ ” button for approximately 2 seconds.
The following tests are available:
•
internal sensor temperature measurement
•
relay test -
press the lower “ ” button repeatedly to switch the relay on/off,
•
backlight test
–
press the upper “ ” button repeatedly to switch the backlight on/off.
•
radio communication level between the thermostat and the receiver (transmit and re-
ceive)
–
press the “
” button.
9.
SWITCHING THE THERMOSTAT OFF
When the switch is moved, the thermostat goes into frost protection mode. icon appears on
the display. Frost protection ensures that the heating is switched on only to prevent the
temperature from dropping below 4
°C.
10.
ERROR INDICATION
OP
–
sensor missing or damaged
SH
–
short-circuit of a sensor or a damaged sensor
Err 1
–
internal error, remove and after a few moments reinstall the batteries
–
discharged batteries icon
Err
and symbol
–
no radio communication.
11.
MAINTENANCE
Do not use solvents and aggressive detergents to clean the thermostat, since they may
damage the surface of the housing and the display. Clean the thermostat housing with a soft
cloth.
12.
RX RECEIVER SETTINGS
12.1.
Establishing a connection between 4010TX thermostat and RX receiver or
receivers (pairing)
Each thermostat and each receiver has a unique number that distinguishes it from others. It is
not possible for any thermostat not paired with the particular receiver to interfere with the
operation of another pair or set.
The thermostat may be paired with other receivers at any time. A blackout, battery
replacement as well as a complete reset of all thermostat settings do not affect the pairing of
devices in any way.
Pairing procedure:
•
Enter the configuration mode in the thermostat
•
Select the pairing mode (P)
•
Press the central button
–
the display shows 0
•
Insert the receiver into the plug socket
•
Press the button on the receiver 3 times
–
the blue LED lights up.
•
When the receiver is detected, the display shows OK and the digit 1 (first receiver)
•
If you are using only one receiver, press the central button and exit the menu. The
pairing mode is ended.
If you are going to pair multiple receivers (maximum 6), proceed as follows:
•
When the first receiver is detected (digit 1 on the display),
•
insert the second receiver into the plug socket.
•
Press the button on the receiver 3 times
–
the blue LED lights up.
•
When the receiver is detected, the display shows 2 (second receiver).
•
Proceed similarly with the connection of subsequent receivers, then press the central
button and exit the menu.
Caution!
The pairing mode is available for 10 minutes after the receiver has been connected to
the mains!