202201-553-ENG
User manual - Mixpro 14
P11
4. USE OF THE MACHINE (continued)
4.2. STARTING UP - FLOOR-SCREED VERSION
1.
Spray the rotor uniformly with lubricant (white assembly spray). Mount the rotor with the crank and
the straight pin (A) by turning clockwise until the rotor is fully inserted. Then loosen it by a quarter
turn.
2. Place the mixing shaft in the tank and tilt the motor (B) vertically. The mixing shaft and the motor
drive nut must be aligned.
3. Insert the locking pin (C) into the 2 holes intended for this purpose (if you cannot insert it, the pin or
the rotor-stator are not correctly fitted, check).
4.
Connect the water inlet hose to the machine’s quick coupling (E), or to the buffer tank if used.
5. Connect the machine electrically.
6. The display (P) indicates AU, unlock the knob (AU) by turning it slightly.
7.
OFF is displayed. Press the ON/OFF button (1) to switch on the machine.
8.
Open the water supply (and the valve on the buffer tank if used).
9.
Press button (7) and open the water valve (F) to prime the water pump (water should come out at a
steady flow).
10.
Close the water valve (F) and press the WATER BACK button (6) to fill the mixing chamber.
11.
Break a bag of powder on the grid (N) in one clean stroke, without shearing or cutting it open with a
cutter.
12. Press button (2) to put the machine in MANU mode (light (L2) on).
13.
The mixture will flow through the product outlet (I). To refine the texture of the product, increase or
decrease the water flow rate (indicated on the display (Q)) using the control valve (G) and the pump
speed using the arrows (4) and (5).
14. Once the desired texture has been reached, return the machine to AUTO mode (light (L3) on) and
clean the product outlet (I).
15. Connect the product hose to the outlet (I) and put the machine in MANU mode, by pressing button
(2), until the product flows out of the hose.
16. Press (2) again to return to AUTO mode, then connect the remote control to the insert (L).
17.
Press the button on the remote control and the machine will start.
18.
Apply the floor-screed with smooth, regular strokes.
Do not force during this operation as this may cause serious damage to the machine.
The water level must not be higher than the water inlet in the mixing chamber (D), otherwise
open the drain (H).
