8
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [email protected]
Introduction
This 2-in-1 Radiant Convection Heater features specially designed internal
structures with large aluminium conductive fins to distribute heat in two
directions: radiant heat through the heat outlet grille at the front, and strong
natural convection heat through the heat outlets at the top. Double reflectors
help protect your floor coverings in front of the heater.
Positioning the Heater
Place the heater in an upright position on a flat, steady, stable, heat-resistant
surface. Make sure there are no flammable or heat sensitive materials or
substances within 1 metre of the heater. Operating the heater in any other
position could cause a hazard.
Connecting the Heater
• The heater is suitable for operation on an AC power supply having the same
voltage listed on the rating label (220-240V 50Hz).
• Before you insert the plug into a suitable wall outlet, ensure the heater is intact,
properly assembled and the cord is undamaged. To avoid overloading a circuit,
only plug the heater into a circuit that has no other appliances connected.
• With both controls set to the Off and minimum positions, insert the plug into
an appropriately installed wall socket and switch on power to the outlet.
• The heater has four heating elements, which can be operated on four heat
settings. It also features a thermostat, which can be set to control the
temperature when three or four elements are switched on. Operation is
explained in detail on the opposite page.
Instructions
WARNING!
• Do not operate the heater without the castor wheel assemblies attached.
• Only operate the heater in an upright position (wheels on the bottom,
controls at the top), any other position could create a hazard.