15
Now mark the location at which the spacer bracket must be screwed to the wall. Remove the fireplace from
the wall, drill both holes and insert a plug. Hang the fireplace on the bracket and screw the spacer bracket to
the wall.
Hang the glass plate (two people are needed for this job!) with the four hooks over the four knobs on the
sides of the fireplace and check that all four hooks are correctly attached (see diagram 4).
Installation is now complete.
Note: ensure that the weight of the fireplace
hangs on the wall supports
and not on the spacer bracket!
Operating
Check that the details on the data plate correspond to those of the electrical supply which you wish to use
for the fireplace. Do not use the same connection for any other equipment.
Install two AAA batteries in the remote control.
Check that the main ON/OFF switch on the right hand, upper side of the fireplace is 'off' (the side with the
circle is depressed).
Now insert the plug into the socket.
Switch the fireplace on with the main ON/OFF switch (depress the side with the stripe). You can now further
operate the fireplace with the remote control or with the buttons on the fireplace itself.
Operating with the buttons:
Pressing the O/I button switches the atmospheric lighting on. The red light next to the button will be
illuminated. Pressing this button again will switch the atmospheric lighting off. If you press the O/I button for
longer than three seconds, the dimmer function will start to work: the brightness of the light will gradually
increase and then decrease. Release the button when the lighting reaches the desired intensity.
Pressing the '1000W' button sets the heating at half capacity (1000 Watt). The red light next to the button will
be illuminated and the ventilator will start to distribute warm air via the upper grille.
Don’t forget! This function
only works if the atmospheric screen is working! Pressing this button again will switch the heating off but the
atmospheric lighting will continue to work.
Pressing the ‘2000W’ button sets the heating at full capacity (2000 Watt). The red light next to the button will
be illuminated and the ventilator will start to distribute warm air via the upper grille.
Don’t forget! This function
only works if the atmospheric screen is working! Pressing this button again will switch the heating off but the
atmospheric lighting will continue to work.
Every time you press a button you will hear a 'beep' and this indicates that the fireplace has 'picked up' the
command.
