18
Turn the heater back over.
Make sure that when in operation, the heater is always positioned on a firm, level,
horizontal surface. Never place it on plush carpet.
Unroll the electric cable fully and plug the plug into a suitable, grounded 220-240V
outlet. Only plug in the heater into a grounded outlet! The standby indicator light
(1) will light up. To avoid overload, check that no other equipment is connected to
the same group.
Use and Operation
1. Standby indicator light
2. 750W power
3. 1250W power
2+3 2000W power
4. Heating Working Indicator
5. Timer
6. LED display
7. Function button
8. Standby button
Press the standby button (8). The display shows the temperature setting.
Turn the function button (7) to set the temperature
Press the function button (7) to set the power. The power lights will light up, if light
is lit up, the heater is operating at 750W, if light is lit up the heater is operating
at 1250W, if both are lit up then the heater is operating at 2000W.
By turning the function button (7), you can set the desired temperature higher or
lower. The device has a thermostat and will heat up until the set temperature is
reached. After that, it will stay at the set temperature. Once the temperature drops
2°, it automatically switches back on.
Attention
: the heater saves the set temperature and choice of power; next time
you turn on the heater, the heater will start with the last thermostat setting and
choice of power you used.
Timer
When you hold down the function button (7) for 3 seconds, the timer light (5)
lights up. By turning the button, you can set the number of hours after which the
device will turn itself off. 1 hour to max. 24 hours. The display shows the set
