00062596.DOC, Version 1.0
16/19
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1:
Open the lampholder cover by loosening the fixation screw.
Step 2:
If replacing the lamp, remove the old lamp from the spot.
Step 3:
Insert the lamp in the lampholder.
Step 4:
Insert the lampholder and close the device.
Do not operate this device with opened housing!
Installing/Replacing the lens
The lenses should be inserted with the bulge facing outwards. This will ensure the following properties:
1. The mounting clamp for the lenses engages with the groove on the lens and in this way prevents the
unintentional falling out of the lens.
2. In case of a possible cracking of the lens, the bulge direction helps prevent single pieces from falling out.
3. The lens has a filter function with regard to the infrared constituent in light. The reflective effect towards
the housing rear panel can only function if the lens has been installed correctly.
Before replacing the lens, remove the color filter frame. Press the holding clip and carefully let the lens fall
forward.
Overhead rigging
DANGER TO LIFE!
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
