00101272, Version 1.0
22/26
Disconnect the LED TSL-150 Scan COB from the controller. Please refer to the instructions under Control
Board.
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED TSL-150 Scan COB you can find an XLR-jack (DMX Out) and an XLR-plug
(DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set „Mast“ - for the master-device, as described in chapter Control Board. Set “Slv1” or “Slve2” for all slave-
devices.
Control Board
The Control Board offers several features: you can e. g. simply set the starting address.
The main menu is accessed by pressing the Mode button. Browse through the menu by pressing Up or
Down. Press the Enter button in order to select the desired menu. You can change the selection by pressing
Up or Down. Confirm every selection by pressing the Enter button. You can leave every mode by pressing
the Mode button. The functions provided are described in the following sections.
Main menu
Sub menu
Function
DMX Set
Address
001-512
DMX address setting
Mode Set
Mast/
Slve1/Slve2
Master/Slave setting
Mast: Master-Mode setting
Slve1: Slave-Mode 1
Slve2: Slave-Mode 2
With this function, you can define the device as slave.
Show Mode
Show 1/2/3/0
Internal programs 0 – 3 (Auto)
Sound Mode
ON/OFF
Sound controlled mode
Sound Sense
0-100
Microphone sensitivity (increasing)
No DMX Set
Blac/Auto/Sound/Hold
Status if no DMX-signal
Blackout/Auto/Sound/Hold
Back Led Light
OFF/ON
Display turn off
ON - Display always on
OFF - Shuts off
the display after a few seconds
Pan Inverse
OFF/ON
Reverse PAN/TILT movement
Tilt Inverse
OFF/ON
Fixture Reset
Yes/No
Reset
Summary of Contents for LED TSL-150
Page 27: ......
