00101272, Version 1.0
20/26
dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note:
for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
DMX-512 connection / connection between fixtures
P
ro
j
ector
1
S
t
a
rting
a
ddress
1
P
ro
j
ector
1
S
t
a
rting
a
ddress
1
P
ro
j
ector
2
S
t
a
rting
a
ddress
10
P
ro
j
ector
2
S
t
a
rting
a
ddress
10
P
ro
j
ector
3
S
t
a
rting
a
ddress
19
P
ro
j
ector
3
S
t
a
rting
a
ddress
19
DMX-512 C
ontro
ll
er
DMX-512 C
ontro
ll
er
120 O
hms
120 O
hms
SAFETY ROPE
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
DMX IN
DMX OUT
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
SAFETY ROPE
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
DMX IN
DMX OUT
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
SAFETY ROPE
POWER SUPPLY:
100-240V~ 50/60Hz
FUSE: T1A, 250V
DMX IN
DMX OUT
LIGHTING CONTROL
PROTOCOL DMX512
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Summary of Contents for LED TSL-150
Page 27: ......
