00101272, Version 1.0
21/26
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution:
At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
resistor
between Signal (–) and Signal (+) in the DMX-output of the last fixture.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
International
Brown Live
L
Blue Neutral
N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
Remove the transport safeties (cable ties) at the mirror completely.
(Only necessary at intitial start-up!)
After you connected the effect to the mains, the LED TSL-150 Scan COB starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the LED TSL-150 Scan COB can be used without controller. You can do without a
controller as the LED TSL-150 Scan COB features a built-in microphone, which provides automatic sound
control.
Summary of Contents for LED TSL-150
Page 27: ......
