00066323.DOC, Version 1.0
24/30
OPERATION
After you connected the effect to the mains, the LED TMH-9 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the LED TMH-9 can be used without controller.
Disconnect the LED TMH-9 from the controller and call the internal program. Please refer to the instructions
under Control Board.
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED TMH-9 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which
can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired master-mode for the master-device and the slave-mode for all slave-devices. Please refer to
the instructions under Control Board.
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-9 will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each LED TMH-9 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-9 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-9 via your lighting controller.
Note:
The modes of DMX 512 data are shown via the display:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the the display will show
" d001."
with the actually set address. If there is no data received at the
DMX-input, the display will show
" d001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
