EuroLite LED Pixel Mesh, User Manual

Page: 9 / 27

7
Communication Wire Facture
Cable from Computer to Scan Board 20m
1 2 3 4 5 6 7 8
INPUT
White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown
OUTPUT
White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown
Cable from Scan Board to Mesh Panel 3,5m
1 2 3 4 5 6 7 8
INPUT
White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown
OUTPUT
Brown White/Brown Green White/Blue Blue White/Green Orange White/Orange
Cable between Mesh Panels
1 2 3 4 5 6 7 8
INPUT White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown
OUTPUT Blue White/Brown White/Blue White/Orange White/Green Brown Orange Green
C-Side 1 8
A-Side B-Side B-Side
Fig. 3
D-Side
Making an additional cable from the computer to the Scan Board
A Standard NET CABLE cannot be used to replace the NET CABLE required to transmit the information for
the LED Pixel Mesh.
Please follow the following instructions in order to create extra NET CABLE.
Take a standard net cable (Cat5/ 5E /6) and connect it to the RJ-45 connector just like displayed on the
picture. The wires should now be colored as following:
1- white & orange
2- orange
3- white & green
4- blue
5- white & blue
6- green
7- white & brown
8- brown RJ-45 Connector
Insert each wire into an RJ-45 connector with the white & orange wire connected to PIN 1, the orange
wire connected to the second PIN, etc.
Both ends of the NET WIRE are connected in this way.