24
•
EN
Interconnecting several showlasers (master/slave operation)
Several showlasers may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller.
The units must be set to the corresponding operating
modes.
1
Configure all slave units before connecting the master unit: Press the
MENU
button so many times until
Addr
is indicated in the display. Confirm with the
ENTER
button. Use the
UP
and
DOWN
buttons to set the start
address to
A001
.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected
in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input
of the master unit.
3
Set the master unit to the desired show program. The interconnected showlasers will now operate in sync.
REMOTE CONTROL
When actuating a button, always hold the remote control in the direction of the sensor at the unit’s front. There
must be visual connection between the remote control and the sensor. In DMX and slave modes, the remote
control is disabled.
Button
Function
Stand By
LEDs and laser beams on/off
DMX
DMX mode
Show 1
Show program 1: LED derby
Show 2
Show program 2: laser
Show 3
Show program 3: LED derby + laser
Show 4
Show program 4: LED derby + laser with changing running speed
Show 5-8
no function
LED Color
Color selection for the LED beams. Change colors (15) by pressing
repeatedly.
LED Random
LED beams with random colors
Laser Color
Color selection for the laser beams. Change colors (3) by pressing
repeatedly.
LED Random
Laser beams with random colors
Sound ON
Enables sound control for show programs 1-4. Set the microphone
SENSITIVITY on the unit (SENSITIVITY L-HI).
Sound OFF
Enables automatic mode for show programs 1-4. Set the running speed
with Speed –/+.
Speed –
Running speed show program 1-3 in automatic mode down
Speed +
Running speed show program 1-3 in automatic mode up
Notes
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
•
If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and at
the same time remove the battery support. For operation, one 3 V button cell type
CR 2025 is required. When inserting, pay attention that the positive pole of the button
cell shows upwards in the support.
