00041967.DOC, Version 1.1
24/30
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution:
At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
resistor
between Signal (–) and Signal (+) in the DMX-output of the last fixture.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the DJ-LED QCF-400 starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards.
The DJ-LED QCF-400 features a built-in microphone and a rotary-control on the rear panel to adjust the
sound sensitivity.
Stand Alone operation
In the Stand Alone mode, the DJ-LED QCF-400 can be used without controller. You can do without a
controller as the DJ-LED QCF-400 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-LED QCF-400 from the controller and select the desired "Master Mode” (Auto/Sound).
