00113517, Version 1.0
37/44
For setting the desired starting address please press the MENU button. Press the UP and DOWN button
until the display shows Addr. Press the ENTER button and the display shows: d001. Set the desired address
via the UP or DOWN button. Please press the ENTER button again to confirm.
Now you can start operating the AKKU IP UP-4 QCL Spot QuickDMX via your lighting controller.
Note:
The modes of DMX512 data are shown via the display of the device:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show
"d.001"
with the actually set address. If there is no data received at the
DMX-input, the display will show
"d001"
with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the wireless receiver is not logged in to the wireless transmitter or no wireless DMX signal is received.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Summary of Contents for AKKU IP UP-4 QCL SPOT
Page 1: ......
