00113517, Version 1.0
34/44
ASC- AC00-AC99
Switching colors
AC00-AC99 (with increasing speed)
FAdE FA00-FA99
Fading colors
FA00-FA99 (with increasing speed)
FLAS FL00-FL99
Strobing colors
FL00-FL99 (with increasing speed)
rL-- r000-r255
Dimmer intensity of red LED color
000 – 255 (increasing)
GL-- G000-G255
Dimmer intensity of green LED color
000 – 255 (increasing)
bL-- b000-b255
Dimmer intensity of blue LED color
000 – 255 (increasing)
UL-- U000-U255
Dimmer intensity of white LED color
000 – 255 (increasing)
SoUA
SO.UA
Sound controlled mode
LEd
oF10/oF30/oF6
0/oF90
Display shutoff
Shuts off the display after about 10, 30, 60 or 90 seconds
nodE nod0-nod4
Dimmer speed (step response)
node0: Response characteristics of LEDs
node1: Response characteristics of halogen lamps, fast
node2: Response characteristics of halogen lamps, less fast
node3: Response characteristics of halogen lamps, middle
node4: Response characteristics of halogen lamps, slow
UErn UEX.X
Software
version
POU- PO-1/PO-2
Power-save mode
PO-1 - power save mode, 50 % power
PO-2 - full power
LOC- on/off
Lock and unlock the keys of the control board
In order to deactivate or temporarily deactivate the keylock function,
press the keys UP and DOWN at the same time.
EUROLITE IR-13 remote control
1
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
2
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not
possible.
3
If the range of the remote control decreases (10 meters as
a maximum), replace the battery. For this purpose, on the
rear side of the remote control press the small bar with the
groove to the right and at the same time remove the battery support. For operation, one 3 V button cell
type CR2032 is required. When inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
not be disposed of with regular domestic waste!
Summary of Contents for AKKU IP UP-4 QCL SPOT
Page 1: ......
