00126630, Version 1.0
30/40
Individual color mix
In the color mode
COL
each of the 4in1 LEDs can be individually adjusted for brightness. The spots will
constantly emit the color adjusted. Select
ALL
to adjust the brightness for all fixtures at the same time.
Select
ALON
to adjust the brightness for each spot individually.
1
Press the button
MENU
so many times until
COL
is indicated in the display. Confirm with the
ENTER
button.
2
Select the desired mode (
ALL
or
ALON
) using the
UP
and
DOWN
buttons. Confirm with
ENTER
.
3
In
ALL
mode, the display indicates the letter
R
for the color red and the corresponding brightness value.
4
Use the
UP
and
DOWN
buttons to adjust the desired brightness.
5
Confirm with
ENTER
. Now the color green can be adjusted; then blue and white.
6
The setting of the strobe speed is the final menu item. Use
UP
and
DOWN
to select the number of the
desired flash frequency from
S.01
(slow) to
S.100
(fast) or
S.00
(no flashing).
7
In
ALON
mode, first select the desired spot (
PAR1
,
PAR2
,
PAR3
or
PAR4
). Confirm with
ENTER
.
8
You can now set the brightness for each spot following the same steps as described above.
Master/slave operation with several light sets
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller.
The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit. For this, press the
MENU
button so many
times until
SLA
is indicated in the display. Confirm with the
ENTER
button. The display now indicates
SLAV
and flashes.
2
Confirm with
ENTER
. The display will continue to flash until control signals are being received from the
master unit.
3
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
4
Select the desired show program or color mode at the master unit. The interconnected light sets will now
operate in sync.
Summary of Contents for 42109860
Page 39: ...00126630 Version 1 0 39 40 ...
