00094546, Version 1.0
32/37
12
S
E
T
O
n
O
F
F
Control via IR remote
Default setting: On
13
W
i
r
e
O
n
O
F
F
Activate W-DMX
De-activate W-DMX
Default setting: On
14
L
i
m
i
O
n
O
F
F
Power saving mode: less bright, yet longer duration
Default setting: On
Wireless Setting
From factory, this projector is prepared for wireless data transmission (WDMX). If you wish to de-activate
WDMX control, you can select the function
“Wire” – “Off”
. With the function
“Wire” – “On”
you can log in
the wireless receiver in to a wireless transmitter, the fixture could now receive the wireless DMX signal.
EUROLITE IR-7 remote control
1
The device must be activated for remote control. For this, under menu item SET,
press the ENTER button to confirm activation.
2
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the rear
side of the remote control. Otherwise operation of the remote control is not possible.
4
If the range of the remote control decreases (10 meters as a
maximum), replace the battery. For this purpose, on the rear
side of the remote control press the small bar with the groove
to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
not be disposed of with regular domestic waste!
No.
Key
Function
Step 1
Step 2
Step 3
Description
1
BLACKOUT
BLACKOUT
any button
Blackout
2
STROBE
STROBE
+/-
Strobe effect
- available for the buttons
AUTO/SOUND/FADE/MANUAL/R/G/B/A/UV/W/0 - 9
3
SPEED
SPEED
+/-
Select the desired speed
Internal programs
4
SENSITIVITY
SENSITIVITY
+/-
Microphone sensitivity
Sound controlled mode
5
%
%
+/-
Dimmer
-available for the buttons AUTO/SOUND/
STROBE/FADE/MANUAL/R/G/B/A/UV/W/0 - 9
6
+/-
AUTO/SOUND/
STOBE/
SPEED/
SENSITIVITY/%
/FADE/
MANUNAL/
/R/G/B/A/UV/W
+/-
Increasing/Decreasing
7
AUTO
Function
1
AUTO
+/-
Internal programms
O 2
AUTO
SPEED
+/-
Desired speed
O 3
AUTO
STROBE
+/-
Strobe effect
O 4
AUTO
%
+/-
Dimmer
8
SOUND
Function
1
SOUND
+/-
Sound controlled mode
O 2
SOUND
SENSITIVITY
+/-
Microphone sensitivity
O 3
SOUND
STROBE
+/-
Strobe effect
O 4
SOUND
%
+/-
Dimmer
