95
GB
Extension cord support
During use of the chain saw. The extension cord will continually be pulled as you move from one
area to another.
A cord retention hook (4) has been provided on the housing of the chain saw to assist in
preventing the electrical connection between the extension cord and chain saw plug being forced
apart. (Fig.14)
Fig.14
Note:
the support is for the extension cord, and not the cable from the chainsaw.
1.
To fit the extension cord to the support. Make a tight loop in the extension cord, approximately
300mm from the socket on the extension cord.
2.
Fit the loop into the rectangle recess in the back portion of the chain saw.
3.
Push the loop all the way through the housing by approximately 25 mm.
4.
Push each side of the loop downwards so each side of the loop fits over the cord retention
hook.
5.
To seat the cable firmly. Gently pull one of the two lengths of extension cable on the right hand
side of the chain saw.
6.
After, and only after the cable is correctly seated, plug the chain saw plug into the socket of the
extension cable.
NOTE: The device is only intended for use in rooms with an operating
current capacity ≥ 100 A per phase. It is also marked as suitable only for
use in rooms with an operating current capacity of 100A or more per
phase.
Operation
Before start-up
1.
Check the tool and cable are in good working order before staring the chain saw.
2.
Make sure that the chain lubrication is working and check the oil level.
3.
Check the chain tension and the operation of the chain brake.
Caution
：
Pass the extension cable over your shoulder and pay attention that it always stays behind you
while you are working. Never pass the cable over the saw chain, it is likely to be caught by the
chain.
Start up
1.
Remove the bar cover (16).
