35
11. OPERATION
a) Manually Setting Time, Selecting 12h/24h Mode
—
Hold down the "MODE" button (5) in normal time display for about three seconds
until the hours flash.
—
Set the hours with the "ADJUST" (7) button (for quick adjustment, keep the button
pressed down).
—
Briefly press the "MODE" button (5); the minutes flash.
—
Set the minutes with the "ADJUST" (7) button (for quick adjustment, keep the
button pressed down).
—
Briefly press the "MODE" button (5); the seconds flash.
—
Use the "ADJUST" (7) button to set the seconds to "00".
—
Briefly press the "MODE" (5) button; the display "12h" or "24h" flashes.
—
Select the 12h or 24h mode with the "ADJUST" button (7).
(
In 12h mode, "PM" is displayed to the left of the time in the second half of the
day.
—
Terminate setting mode by briefly pressing "MODE" (5).
Setting mode is terminated automatically (and all settings are stored) if no button
is pressed for 30 seconds.
(
If the basis station recognises a proper DCF signal during the daily reception
attempts, the time is set again automatically.
If you want to switch the DCF display between 12h- and 24h-display, proceed
as described above anyway, but only change the 12h-/24h-mode setting. The
DCF icon "
" disappears until the next successful reception attempt for the
DCF signal.
You may also initiate a DCF receiver attempt manually. Keep the button
"SNOOZE/LIGHT" pressed for about 3 seconds.
