Euroboor TUBE.30, Operator'S Manual

Page: 6 / 31

6
Service
1. Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result inrisk of injury;
2. When servicing a tool, use only identical replacement parts. Follow instructions in the
maintenance section of this manual. Use of unauthorised parts or failure to follow maintenance
instructions may create a risk of electric shock or injury;
3. EUROBOOR offers armature kits containing official EUROBOOR spare parts suitable for your
magnetic drilling machine.
1.2 Specific safety information
• Keep your fingers away from the drilling area;
• Avoid touching the slug that is automatically ejected by the pilot pin when the working procedure
is finished. Contact with the slug when it is hot, or if it falls, can cause personal injuries;
• Always use the safety guard. Before switching on the machine ensure that the guard is closed
securely;
• Always use the safety chain;
• The magnetic drilling machine is suitable for use on round and flat steel with a thickness starting
from 3 mm. Curvature, coats of paint and surface irregularities will create a distance between the
magnets and the steel. Keep it to a minimum;
• Do not clamp the magnetic drilling machine on small or irregular shaped objects;
• Always place the machine on a surface that is clear of shavings, chips, swarf and surface dirt;
• Keep the magnet clean and free of debris and swarf;
• Do not switch on the machine before checking whether the magnetic stand has been tightened
firmly to the mounting surface;
• Adjust the machine so cutter does not extend into the workpiece before drilling. Do not perform
any design, assembly or construction activities on the workpiece while the machine is switched
on;
• Before switching on the machine, make sure all accessories have been mounted correctly;
• Do not switch on the machine until it has been mounted and installed according to all above
mentioned instructions;
• Always use the recommended speed for the accessories and material you are working with;
• Do not use the machine on the same workpiece on which electric welders are working;
• Only use an appropriate cutting lubricant. EUROBOOR offers a wide range of well-considered
cooling and lubrication products to match your requirements;
• Do not use liquid cutting fluids while drilling vertically or overhead. Dip the cutter in cutting paste
or apply an appropriate spray for these applications;
• Do not pour cutting fluid into the reservoir while it is mounted in the bracket. Do not allow
cutting fluid to enter the drill motor;
• Before use, ensure movable safety guard operates properly;
• In case of a jammed cutter, turn of the machine, disconnect the machine from the power supply
and then remove the reason for the jam before turning on the machine again.