Euroboor TUBE.30, Operator'S Manual

Page: 12 / 31

12
3. Preparation & adjustment
3.1 Assembly
WARNING:
To reduce the risk of injury, turn unit off and disconnect machine from power source
before installing and removing accessories, before adjusting or changing set-ups or when making
repairs. Be sure all switches are in the OFF position. An accidental start-up can cause injury.
Fitting the feed handles
1. Fit each of the three feed handles by screwing them into the hub in clockwise directions
2. Tighten firmly by hand
The handles are supposed to face slightly outward. Be careful not to cross-thread any of the
components.
Fitting the lubrication system
The lubrication system can be used for horizontal drilling
applications (the drill being used vertically).
1. Hang the coolant tank (A) on the coolant tank holder
2. Position and tighten the attachment pin (B)
3. Connect the coolant hose (C) to the fitting on the
gearbox. Make sure the hose is connected fully and
tightly
4. To disconnect the coolant hose, press the blue ring on
the connection and gently pull out the hose
[image 3-1]
WARNING: Do not use the lubrication system in vertical or overhead drilling applications. Instead
use EUROBOOR cutting paste or spray.
Fitting the safety chain
1. Pass the safety chain through the opening near the grip;
2. Wrap the chain around the work piece;
3. Securely close the chain using the lock.
WARNING:
Always use the safety chain when using machine vertically and/or upside-down. The
safety chain does not replace the magnetic force of the magnetic drilling machine: it is simply
used to secure against falling in the event of a magnet malfunction.