www.euroboor.com
18
3.3 Fitting the blade
WARNING:
Before undertaking any type of preparation or adjustment, make sure
the machine is switched off and the power supply is disconnected.
1.
Remove the spindle cover by loosening the two bolts
using the
M6 hexagon key.
2.
Put on the spindle lock by using the spindle lock lever.
Carefully rotate the spindle, by hand, until the spindle
lock locks in place.
After the spindle is locked, keep the lock on and at the
same time, loosen the spindle bolt using the M10
hexagon key.
3.
When the spindle bolt is loosened: remove the small flange and the front-flange from
the driveshaft.
Note:
Keep the back-flange in place.
4.
Raise the retractable blade cover to its highest position.
While remaining in that position, the sawing blade can be
placed onto the spindle.
Note:
Check the blade for cracks or other damage before
operation. Do not use blade when it is damaged or
deformed. Also check if the blade can run freely and
without vibrating.
