12
3. Preparation & adjustment
3.1 Assembly
WARNING:
To reduce the risk of injury, turn unit off and disconnect machine from power
source before installing and removing accessories, before adjusting or changing set- ups or
when making repairs. Be sure all switches are in the OFF position. An accidental start-up can
cause injury.
FITTING THE FEED HANDLES
1.
Fit each of the three feed handles by screwing them into the hub in clockwise directions
2.
Tighten firmly by hand
The handles are supposed to face slightly outward. Be careful not to cross-thread any of the
components.
MOUNTING THE DRILL GUARD
The guard protecting against chippings and accidental contact must always be mounted during
operation.
1.
Hold the guard in front of the magnet, aligning the slots in the guard with the holes in the
magnet.
2.
Fit the screws into the hole located in the side of the magnet.
WARNING:
Always use the Safety guard.
FITTING THE LUBRICATION SYSTEM
The lubrication system can be used for horizontal drilling
applications (the drill being used vertically).
1.
Hang the coolant tank (A) on the coolant tank holder
2.
Position and tighten the attachment pin (B)
3.
Connect the coolant hose (C) to the fitting on the Morse
Taper spindle. Make sure the hose is connected fully and tightly
4.
To disconnect the coolant hose, press the blue ring on the
connection and gently pull out the hose
[image 2-1]
FITTING THE SAFETY CHAIN
1.
Pass the safety chain through the frame grip opening
2.
Wrap the chain around the work piece
3.
Securely close the chain using the lock
WARNING:
Always use the safety chain when using machine vertically and/or up-side-down.
