Euroboor ECO.50+/T, User Manual

Page: 19 / 37

19
Power surge protection
The machine is able to cope with voltage spikes up to
4,000V (1-2 μs )
.*
Power fluctuation protection
The machine is able to cope with voltage and frequency fluctuations ranging from:
110 Volt to 130 Volt - 45 Hz to 65 Hz
220 Volt to 240 Volt - 45 Hz to 65 Hz
When the frequency is too high or too low, so it falls outside of above mentioned range, the motor
will not start. If the frequency of the power supply falls outside the range or fluctuates strongly
during your drilling job, the motor shut off automatically.*
* Disclaimer: Euroboor is not liable for any damage caused to the machine due to electrical
problems in the workplace. Above mentioned protection is not guaranteed in all cases of voltage
and frequency spikes or fluctuations. Euroboor accepts no liability when it come to the power
surge or fluctuation protection not functioning or functioning poorly.
In the situation of the motor being shut off automatically as self-protection, you should:
- Shut off the magnet;
- Disconnect the machine from the power source;
- Fix the source of the problem, by either;
o
Making sure the issues with the power source is fixed;
o
Connect the machine to a different and reliable power source;
- Continue using the machine as described in this user manual.
4.7 Overheat protection
This machine is supplied with an all-time electronic overheat protection. If the temperature of the
motor unit runs up to 70° C (158 °F) the motor unit will stop. After a few minutes it can be started
again. When it is possible to start the motor again, let the motor run idle at full speed for a couple of
minutes to let the motor cool down more in an efficient way.
4.8 Carbon brushes
This machine is equipped with carbon brushes with two protection features. The purpose of both
features is to schedule timely service and avoid additional costs by unexpected downtime or
unnecessary part replacement.
Carbon brush wear indicator
On top of the motor housing you will find an integrated LED light. Under normal circumstances this
light is off. The LED light will start burning red when the carbon brushes are worn to a level where it
is advised to replace them.
Actual remaining operating time depends on the use of the machine, but can be at least twelve
operating hours. This makes it possible to schedule service of the machine and avoid unexpected
downtime.