15
461307208 (RS-002)
C
L
16
STRUCTURE
All the cooker parts (in enamelled or painted metal, steel, or glass) should be cleaned frequently with warm soapy
water and then rinsed and dried with a soft cloth.
DO NOT use harsh abrasive cleaners or sharp metal scrapers to clean the oven glass door since they can
scratch the surface, which may result in shattering of the glass. NEVER use sponges or abrasive products, and
aromatic or aliphatic solvents to remove stains or adhesives on the painted or stainless steel surfaces.
OVEN CAVITY
Do not spray or wash the thermostat bulb with acid based products (check the product label before
use). The manufacturer cannot be held liable for any damage caused by incorrect cleaning.
The oven cavity should be cleaned after each use to remove cooking residuals and or grease or sugar which, if
burnt on when the oven is used again, will form deposits or unremovable stains as well as unpleasant smells.
To maintain the shine of the enamelled parts, clean them with warm soapy water, rinse and dry them thoroughly.
ALWAYS wash the accessories used.
Note: At the end of this operation, correctly put again the shield (S) (fi g. 11). Take care to not scratch the
enamel of the bottom plate, moving this shield.
OVEN SEAL
The oven seal guarantees the correct functioning of the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is damaged, contact our Service Centre and avoid using the
oven until it has been repaired.
REPLACING THE OVEN LAMP (fi g. 16)
Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric
shock.
In the event oven lamp need replacing, the new lamp must comply with the nominal data indicated on page 25
and must be resistant to high temperature (300°C). Turn glass protection cap (C) counterclockwise and change
the lamp. Re-fi t the cap, screwing it back in a clockwise direction.
INSTRUCTIONS FOR THE USER
