5.
Install housing.
Conduct cables through the top hole of the
housing, and then turn the housing thread pipe
head into suspender and fasten the connection
with two M5 screws
NOTE: Apply water-proof tape to the thread in
the case of outdoor dome. If installation height is
not high enough, mount housing directly into the
base.
6.
Connect cables.
Plug cables into corresponding sockets on circuit
board. Reinstall the circuit board and turn on the
power. The red LED is on if connections are
correct. Turn off the power after checking.
NOTE: Names of the interfaces are marked on
terminal block or PCB. Connect cables as
picture shows. Make sure power is off before
connecting.
7.
Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by
configuring DIP switches (see APPENDIX I).
Remove the packing sponge.
SW 1
SW 2
8.
Down cover preliminary installation.
Attach the safety chain with a M3 nut as picture
shows.
NOTE: Connect plug into the socket on heater in
the case of outdoor dome
EVC-TP-SO453ARW, EVC-TP-SO448AN
www.eurovideo-cctv.com
- 17
-
- 17
-
