TS301;351 TS301/45;351/45 - 10 -
SEP. 2007
ENGLISH
1. THE MACHINE DOES NOT WORK
POSSIBLE CAUSES
REMEDIES
Not plugged in properly or cable damaged
- Make sure that the supply is correctly
plugged in (plug, extension lead, etc.)
- Check the supply cable
No mains voltage
-
Test or have tested by an electrician (circuit breaker, plug, etc.)
Switch defective, motor cable damaged
- Have tested by an electrician or contact the service department
Motor faulty (burned out)
-
Contact the service department to have the motor replaced.
Overloaded motor triped
- Wait a few minutes for the motor to cool down.
- 115 V Machines – Prees in “overload” and then the green
start button.
- 230 V Machines – Press green start button.
2. NO WATER SUPPLY
POSSIBLE CAUSES
REMEDIES
No water supply
- Fill up clean water in water tank
Pump does not work
- Clean strainer
3. THE PUMP DOES NOT START
POSSIBLE CAUSES
REMEDIES
The mains lead is not correctly connected or is
damaged
- Check the mains lead
No voltage in pump circuit or mains supply circuit
- Check the pump circuit and mains supply circuit
***
Prior to any maintenance work, the machine must be disconnected from the power supply.
•
Clean the machine daily.
•
Drain the water reservoir regularly.
•
Remove all mud and silt deposits in order to avoid the clogging of the water pump.
•
Rinse water pump filter daily.
•
Check daily that the rails are kept clean.
•
In the event of uneven or sluggish cutting, the blade must be cleaned by pressing a silicat or any other
abrasive stone lightly against it while spinning.
FAULT FINDING
MAINTENANCE