Euro-Pro Shark 7133, Instruction Manual, Page: 87 / 107

GB
78
0
1
2
3
4
S
0
1~5
5
0
1
2
3
4
- Set the machine as illustrated.
- Remove the presser foot and the presser foot holder.
- Move the drop feed control to right side to lower the feed dogs.
(1)
- Lower presser foot lever before starting to sew.
- Adjust the stitch width according to the size of lettering or design.
- Draw the desired lettering or design on the right side of the
fabric.
- Stretch the fabric between embroidery hoop as firmly as
possible.
- Place the fabric under the needle. Make sure the presser foot
bar is down in its lowest position.
- Turn the balance wheel towards you to bring up the lower thread
through the fabric. Sew a few securing stitches at the starting
point.
- Hold the hoop with thumb and forefingers of both hands while
pressing the material with the middle and third fingers and
supporting the outside of hoop with smaller finger.
* Embroidery hoop not included with machine.
Preparation for Monogramming and Embroidering*
Monogramming and embroidering with embroidery hoop*
B
2
1
a
b
a b