Step 5
2.Put the support rod into the hole on the hopper using Hex Bolts M6x20, Big Flat
WashersØ6 and
Step 6
M8 and don't screw them up moderately.
1.
Connect Adjust Handle Assembly and Support Bar by using two Bolts M8x40 and two Nylon Lock Nuts
nylon Lock nuts.
1.Put the Hopper Screen into the end of Hopper Assembly(see illustration j)
2. Install one Flat Washer Ø8 at the lower head of Adjust Rod and then insert into the hole of Rod Base.
Conncet them by using a Nylon Lock Nut M8. (see illustration k and l)
of assembly.
2. Install one Flat Washer Ø8 at the lower head of Adjust Rod and then insert into the hole of Rod Base.
3. Adjust the Adjust Handle back and forth to make the Active Adjustable Plate to be able to fully open
to close. Then screw up the two Nylon Lock Nuts M8 that used to fix the whole set
