Step3
Bolt M6x50 and Nylon Lock Nut M6 ,don't screw them up temporarily.(see illustration e)
Plate Support Tube by using Bolt M6x50 and Nylon Lock Nut M6,don't screw them up
temporarily. (see illustration f)
the round part of Install Tube Assembly by using Bolt M6x50 and Nylon Lock Nut M6.
(see illustration g)
4.Adjust the position of
Hitch Tube,Across Rod
and Brace to the properly
location,then tighten all
nuts(in illustration c-g)
up.
1
.
Connect two Hitch Braces (each at one side) and the hole at the back of Hitch Tube by using
2.Connect two Hitch Braces (each at one side) and the hole at the middle of Adjust
3. Connect another end of two Braces at each side of Hitch Tube with the hole in horizontal direction at
Step 4
of the Hoper Assembly
to make the axle to be
able to twirl freely
and then screw all
the Nylon Nut M6.
(see illustration h)
into the hole on top
of Swivel Axle.
(see illustration i)
3.Insert the R Pin Ø3x75
M6x50 with Big Flat WasherØ 6 and Nylon Flat Washer on the top and six Nylon Lock Nut M6. Adjust parts
2. Aligning all the six holes around Hopper Assembly and the six holes on the Frame by using six Bolt
1. Insert the head of Axle on Frame Tube Assembly into the Swivel Bushing at the bottom of Hopper Assembly
