3
INSTALLATION
Install the unit in hard & flat floor, keep the room ventilated.
Leave at least 20cm space
around the unit (when the hose is not connected).
1. Push the rubber adaptor of the water pipe on the drainage port of rear panel. Please refer
the following picture.
2. Connect the water pipe to bathroom, outdoor or a container, such as bucket.
NOTE:
1. Do not block the drainage port or water pipe.
2. Do not fold the water pipe or make it 1.5m higher than the bottom of unit.
3. Do not replace the rubber adaptor of the water pipe, it’s the special accessory for the unit
only, other adaptor may not fit the unit. If it’s damaged or lost, please call the customer
service for replacement.
.
